Advertisement
General Problems
Check
Is the detection range set correctly?
PRINTING IS NOT POSSIBLE OR STOPS DURING
?
A JOB
Check
Is a tray out of paper?
Is the machine out of toner?
Has a paper misfeed occurred?
Is the output tray full?
Is the waste toner box full?
Are restrictions placed on the trays
that can be used in each mode (copy,
print, image send, and document
filing)?
Solution
!
■ Adjust the detection range.
Solution
!
■ Add paper as instructed by the message in the touch panel.
■ Replace the toner cartridge.
► Maintenance (page 6)
■ Remove the misfeed as instructed by the message in the touch panel.
■ Remove the output from the tray and resume printing.
When the output tray becomes full, a detector activates and stops printing.
■ Replace the waste toner box as instructed by the message in the touch panel.
■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the
checkboxes of each mode ([Feeding Approved Job]).
Functions without a checkmark cannot be used for printing using that tray.
"Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job]
12
Motion sensor
Near
Far
Hide quick links:
Advertisement
