Advertisement
General Problems
WHEN PRINTING ON THICK PAPER, THE PRINT
?
RESULT IS DIRTY FROM THE 2ND PAGE ON
Check
Has the paper type been set
correctly?
I DON'T KNOW HOW TO CHANGE THE OUTPUT TRAY
?
Check
Did you change the output tray?
PART OF THE IMAGE IS CUT OFF
?
Check
Has the correct paper size been set?
Was the original placed in the correct
position?
Solution
!
■ Set the correct paper type in the tray settings. Make sure that the following did
not occur:
• When using heavy paper, change the paper type in the tray settings to Heavy.
(The image may disappear if rubbed.)
• Paper other than heavy paper is being used, but heavy paper is selected in the
tray settings. (This may cause creases and misfeeds.)
"Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
Solution
!
■ When copying, you can select the output tray in normal mode. Tap [Output] in the
base screen of normal mode. You can set the output tray in the screens.
When printing, you can select the output tray in the printer driver. Click the
[Finishing] tab in the printer driver, and select the output tray in [Output Tray].
The output tray is fixed and cannot be changed when some copy or print settings
are selected. Some copy or print settings may be canceled when you change the
output tray.
Solution
!
■ If you are using a non-standard size, be sure to specify the paper size.
If the size of paper loaded into a tray was changed, be sure to check the paper
size setting.
"Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
■ If you are using the document glass, be sure to place the original in the far left
corner of the document glass.
► Placing the original and adding paper (page 5)
18
Hide quick links:
Advertisement
