Sim Connector Board - HP Compaq 6735b Maintenance And Service Manual

SIM connector board

NOTE:
Description
SIM connector board
Before removing the SIM connector board, follow these steps:
1.
2.
3.
4.
5.
Remove the SIM connector board:
1.
2.
94 Chapter 4 Removal and replacement procedures
Downloaded from www.Manualslib.com
This section applies only to computer models equipped with a WWAN module.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
Remove the battery (see Battery on page
Remove the following:
a. Hard drive (see Hard drive on page
b. Optical drive (see Optical drive on page
c. Keyboard (see Keyboard on page
d. Switch cover (see Switch cover on page
e. Display assembly (see
f. Top cover (see Top cover on page
g. Rear cover (see Rear cover on page
Remove the two Phillips PM2.5×5.0 screws (1) that secure the SIM connector board to the base
enclosure.
Lift the left side of the SIM connector board (2) to disconnect it from the system board.
manuals search engine
47).
53)
56)
61)
66)
Display assembly on page
81)
92)
Spare part number
486252-001
75)