Table of Contents
Advertisement
Power the MR20-HW
If mounting to an electrical junction box, feed the Ethernet cable through the cable
access hole in the mount cradle. If mounting to a wall or ceiling, the Ethernet cable will
feed from behind the MR20-HW. The
"Power Source
Options" section of this document
lists the different powering options and their unique characteristics.
Mount the MR20-HW
Attach the MR20-HW to the Mount Cradle
(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box
mount
where you have already installed the mount cradle.)
The MR20-HW attaches to the mount cradle with two tabs on the cradle that insert into
the MR20-HW, and is secured to the cradle using one screw.
To attach the MR20-HW to the mount cradle properly, line up the top edge of the AP with
the top tab of the mount cradle. Since the cradle is already mounted to the wall, guide
the MR20-HW towards the top tab and insert the top tab into the MR20-HW's slot.
Advertisement
Table of Contents
