Advertisement
Step 8
Q21
Each wall panel has a crimped rib
on one side. The crimped rib should
go under the rib of the panel that
follows it.
1
Locate all of the wall panels and
set each one alongside the building.
2
Fasten the wall panels at the top
and bottom with screws.
3
Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using a bolt and nut
with two screws.
4
When you have attached all wall
panels in the correct positions, the
building will look like this.
Parts Needed For
Wall Panels
STEP
1
6515
6515
Panels rest on
frame as shown
Crimped Rib
Underneath
Use bolts and
nuts thru wall
angle overlap
at the top of
panel at rear.
STEP
4
21
6515 Wall Panel (6)
6515 6515
Detail Showing
Center of Panel Screwed
to Wall Channel
Bolt and nut
does not go thru
STEP
wall channel
3
at overlap
STEP
2
6515
6515
Advertisement
