Advertisement
Step 1
Q14
The front oor frame is made up of
three pieces. The rear oor frame is
made up of two pieces. The holes
in these pieces will align when the
pieces are positioned with correct
amount of overlap. The illustrations
below show the proper overall length
for the front and rear. Proceed as
follows:
1
Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front oor frames. Join the frames by
inserting eight screws.
2
Overlap the rear oor frames as
shown. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. See
the illustrations below for the proper
overall length of the rear oor frame.
Join the frames by inserting ve bolts
into frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Parts Needed For
Floor Frame Assemblies
9367
STEP
1
9367
STEP
2
STEP
3
14
8934 Ramp (1)
9367 Front Floor Frame (2)
8936 Rear Floor Frame (2)
8934
9367
8934
DRAIN HOLES FACE
OUTSIDE
8936
119 3/8" 303,2 cm Front
8936
Front Floor
Frame Assembly
119 3/8" 303,2 cm
9367
Rear Floor Frame
119 3/8" 303,2 cm
8936
119 3/8" 303,2 cm Rear
Advertisement
