Table of Contents
Advertisement
Replacing important components
7
Fig. 4
Replacing the light-beam localizer lamp
•
The replacement light-beam localizer lamp is located below the cassette tray.
•
Turn both knobs (8/Fig. 4) to an end position and remove them.
•
Remove front panel after loosening both screws (7/Fig. 4) .
Caution: The frontpanel is connected to the collimator via cables (9/Fig. 5).
•
Loosen both screws (10/Fig. 5) and unscrew the bracket carrier of the temperature
switch).
•
Take out the defective lamp (11/Fig. 5) and replace it by a new lamp.
CAUTION:
HINWEIS:
•
Screw down the bracket and the front panel.
•
Adjust both knobs and fasten them.
Siemens AG
Medical Solutions
8
Do not touch the glass envelope with your bare fingers.
Fig. 5
RXB8-115.061.02
Rev. 01
10.95
9
Page 3 of 6
CS PS 24
5 - 3
10
11
5
POLYMOBIL III
Advertisement
Table of Contents
