Figure 85. Pivoting the drive bay assembly upward
4. Locate the primary hard disk drive. See "Internal storage drives" on page 7.
5. Disconnect the signal cable and the power cable from the hard disk drive.
6. Pull the blue handle to slide the hard disk drive out of the drive cage.
Figure 86. Removing the primary hard disk drive
7. Flex the sides of the blue bracket to remove the hard disk drive from the bracket.
8. To install a new hard disk drive into the blue bracket, flex the bracket and align pin
pin
4
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit board
5
on the bottom of the hard disk drive.
100
P320 User Guide
1
, pin
2
, pin
3
, and