Table of Contents
Advertisement
C
C
C
C
C
C
C
C
C
C
CARE AND CLEANING
C
A
A
A
A
A
A
A
A
A
A
R
R
R
R
R
R
R
R
R
E
E
E
E
E
E
E
E
E
E
A
A
A
A
A
A
N
N
N
N N
N
N
N
N
D
D
D
D
D
D
D
D
D
D
D
D
CLEANING
CLEANING THE EVAPORATOR FILTER
AND EVAPORATOR
Clean the evaporator and the evaporator fi lter at the
intervals shown on the machine's display or more often.
1. Turn off the Main power switch and open the outer
door.
2. Remove the plinth.
3. Open the heat pump door.
4. Pull out the fi lter by lightly pressing the fi lter support
downwards.
5. Remove the sponge fi lter (B) from the fi lter support
(A). Clean it with a vacuum cleaner and wash it under
running water.
A
RECOMMENDATION!
Wash the sponge fi lter in the washing machine after 30
drying cycles (use the rinse or quick wash program).
6. Clean the heat pump ribs by spraying water on them
(use a plant sprayer). The water will carry away the
lint and the condensate pump will drain the lint and
water mixture.
7. Replace the clean sponge fi lter into the fi lter support.
To replace the support, fi rst insert the bottom edge of
the support under an angle, and then lightly press it
towards the heat pump ribs to align it. Close the heat
pump door.
NOTE!
Do not touch the heat pump ribs. They are very thin
an easily damaged. If the ribs are bent or damaged,
the effi ciency of the condenser unit will deteriorate
considerably, which in turn leads to poorer drying
results.
B
15
Advertisement
Table of Contents
