Table of Contents
Advertisement
INSTALLATION
I
I
N
N
S
S
S
S T
T
T
T
T
T
T
T
T
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
A
A
A
A
A
A
A
A
A
A
WARNING!
Do not start the machine until it has been in position for
24 hours. If for some reason the tumble dryer needs to
be laid down for transport or service, it must be laid on
its left side viewed from the front.
POSITIONING THE TUMBLE DRYER
The tumble dryer can be free-standing or in a stack.
Remember that the tumble dryer produces heat and
should therefore not be located in a room that is too
small. If the room is very small, drying will take longer
due to the limited quantity of air.
NOTE!
• Do not install the machine in a room where there
is a risk of frost occurring. At temperatures around
freezing point the machine may not be able to
operate properly.
• The room in which the appliance is installed should
be adequately ventilated, with temperature between
15°C and 25°C.
WARNING!
• Any electrical installation must be carried out by
qualifi ed professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with hinges
on the opposite side to those of the tumble dryer.
• The tumble dryer's plinth ventilation must not be
blocked by a rug or the like.
NOTE!
To improve ventilation, leave the door to the room
where the tumble dryer is located open.
Freestanding
The tumble dryer can be positioned beside the washing
machine.
If the customer has a problem with the machine sliding
when on a low-friction fl oor, the plastic cups can be used
under the feet of the tumble dryer (between foot and
fl oor).
Stacking
The tumble dryer can be placed on top of a ASKO
washing machine. In this case you use the stacking
attachments (foot cups and anti-tilt devices) that come
with the machine. Two rubber feet and two anti-tipping
brackets are supplied in the bag found in the drum of the
dryer.
20
TIO
O N
How to assemble the stack:
1. Undo the screw on the back of the ASKO washing
machine as shown in the fi gure.
2. Secure the anti-tilt device using the screws as shown
in the picture.
3. Take the other anti-tipping bracket from the bag and
attach it on the dryer with two screws as shown in the
fi gure.
4. Place the two rubber feet on the front feet of the
dryer.
Advertisement
Table of Contents
