Furuno FAR-2228-BB Operator's Manual page 266

APPENDIX 3 ALERT CODES, MESSAGES & MEANINGS
ALR ALF
Alert ID Alert ID
- 52729,01 POSN INT ERROR
Remedy: Press the ALARM ACK key. Check the output settings for the connected EPFS device.
Adjust output interval (cycle) as required.
792 52792,01 CHART ERROR*
Remedy: Press the ALARM ACK key. Have a qualified technician check the processor unit.
755 52795,01 SART DETECTED*
Remedy: Press the ALARM ACK key. Show the SART marks on the radar display, referring to
section 2.3.2.
When LOG(WT) is not selected, the alert priority for this alert is changed to "Caution". Caution
1
* :
level alerts are not shown on B/W-type radars.
When LOG(BT) is not selected, the alert priority for this alert is changed to "Caution". Caution
2
* :
level alerts are not shown on B/W-type radars.
This alert is output only on R-type radars.
3
* :
This alert is output for magnetron radars only.
4
* :
5 This alert appears on S-BAND SSD radars only.
* :
This alert is output only on A/B/W-types with radar plotter functionality.
6
* :
When no AIS data is received, the message "AIS COM ERROR" appears in the Alert Box.
7
* :
Check connection with the AIS transponder.
When the AIS function is disabled: Above message is prioritized as a Caution level alert for
IMO/R-types. A/B/W-types do not show this alert.
When the AIS function is active: Above message is prioritized as a Warning level alert for all
radar types.
For R-type radars only, this alert has the following attributes: ALR number: 533, Priority: Warn-
8
* :
ing, Category: A.
9 This alert appears only on A/B-type radars when Dual Radar mode is active and enabled.
* :
: This alert appears only for FAR-2228-NXT(-BB) and FAR-2328-NXT. Keep in mind the following
10
*
points:
• The "SART DETECTED" alert can occur when this equipment receives interference simulta-
neously from multiple radars.
• The "SART DETECTED" alert may not occur under the bad weather conditions such as at
rain.
AP-20
Priority &
Alert title
Category
Caution
Cat: B
Warning
6
Cat: B
Warning
10
Cat: B
Alert description
Message: "POSN INTERVAL ER-
ROR"
Meaning: Positioning interval (Lat/Lon)
cycle has exceeded 10 seconds for a
period of three minutes or more.
Message: "CHART MEMORY ER-
ROR"
Meaning: An error has occurred while
loading chart data.
Message: "SART DETECTED"
Meaning: A SART signal was detected.