Furuno FAR-2228-BB Operator's Manual page 244

6. MAINTENANCE, TROUBLESHOOTING
Tested item
RP Board (For A/B/W-types with Radar Plotter functionality only)
[PROGRAM No.]
[IP ADDRESS]
[CHART MEMORY RP]
[USB MEMORY RP]
RP [1.8V]
[3.3V]
[5.0V]
[TEMP]
[FAN]
SPU (Antenna)
[PROGRAM No.]
[ROM]
[RAM]
[DIP SWITCH]
[BOARD REV]
[IP ADDRESS]
[SPU] [TX TYPE]
[12V]
[5V]
[3.3V]
[2.5V]
[1.8V]
[1.25V]
[1.2V_1]
[1.2V_2]
[3.3V_A]
[-10V]
[TX HV]
[MAG HEATER VOL]
[MAG HEATER CUR]
[IF 5V]
[IF -10V]
[MD 12V]
[ANT SPEED]
[MAG CURRENT]
(Continued on following page)
6-10
Normal value or Description
Magnetron Radar
Shows the program version number.
Shows the IP address of the RP board.
OK
OK
1.6 to 2.0 V
3.0 to 3.6 V
4.7 to 5.3 V
-15 to +90°C
3700 to 5700 rpm
Shows the program version number.
OK
OK
Shows the DIP SWITCH settings.
Shows the revision number for each PCB.
Shows the IP address for the Processor Unit.
X-12kW/X-25kW/S-30kW
11.4 to 12.6 V
4.75 to 5.25 V
3.18 to 3.42 V
2.4 to 2.6 V
1.71 to 1.89 V
1.19 to 1.31 V
1.14 to 1.26 V
1.14 to 1.26 V
3.18 to 3.42 V
-10.5 to -9.5 V
500 to 560 V
• X-Band, 12 kW:
8.1 to 8.6 V or 6.8 to 7.3 V
• X-Band, 24 kW:
7.0 to 7.5 V or 5.7 to 6.2 V
• S-Band:
7.4 to 7.9 V or 6.3 to 6.8 V
• X-Band: 0.5 to 0.6 A
• S-Band: 1.1 to 1.4 A
4.75 to 5.25 V
-10.5 to -9.5 V
11.4 to 12.6 V
• 24 rpm antennas: 22 to 26 rpm
• 42 rpm antennas: 40 to 44 rpm
• X-Band: 5.0 to 12.0
• S-Band: 6.0 to 10.0
Solid State Radar
S-Solid
"not connect"
"not connect"
"not connect"
"not connect"
"not connect"
"not connect"
"not connect"
"not connect"