Omron SYSMAC CS1W-ETN21 Operation Manual page 96

Send Mail
Item
Mail Soft- If this option is selected, mail is sent whenever the
trigger ware Mail Send Switch turns ON.
type switch
The Mail Send Switch is bit 03 of word n in the
(Select
words allocated for CPU Bus Units. (n = 1500 + 25
only
x unit number)
one.)
Word If this option is selected, the value of a specified
value address is compared with a standard comparison
change value using one of the following comparison func-
tions, and mail is sent whenever the condition is
satisfied.
=, <>, <, <=, >=, >
Select the address for storing the comparison
value from the drop-down list.
Bit value If this option is selected, mail is sent whenever a
change specified bit turns ON or whenever it turns OFF.
Select the bit address from the drop-down list
below.
ETN If this option is selected, mail is sent whenever a
condition new error is stored in the Ethernet Unit's error log.
CPU If this option is selected, mail is sent whenever any
condition of the following conditions occur at the CPU Unit.
The drop-down list at the right can be used to
select which of these three are to serve as mail
triggers.
• When a non-fatal error occurs
• When a fatal error occurs
• When the operating mode is changed
Interval If this option is selected, mail is sent at fixed time
time intervals.
(Peri-
The time interval (in minutes) can be set in the
odic
interval time box.
timer)
Mail address Select the destination mail address.
The mail destination is the one set under the Mail
Address tab.
Send user data If this option is selected, user-created data is sent
in the body of the mail.
The location for storing the user-created data is
set by the user-defined mail address setting
below.
Send Error Log If this option is selected, the error log is included in
information the body of the mail.
Send status infor- If this option is selected, status information is
mation included in the body of the mail.
Send file data/I/O If this option is selected, any of the following types
memory data of data can be sent as file attachments to e-mail.
• I/O memory data (.IOM)
• I/O memory data (.TXT)
• I/O memory data (.CSV)
• File data (any file)
Select the type of data to be attached from the
checkboxes below. If I/O memory data is selected,
then also select, in "I/O memory data" below, the
address and range of data to be sent.
Attached file If the above setting is checked so that files can be
name sent as attachments, then specify the name of the
file that is to be sent.
Contents
Section 3-7
Default
Checked
Not checked
Not checked
Not checked
Not checked
Not checked
Address 1
Not checked
Not checked
Not checked
Not checked
None
71