Table of Contents
Advertisement
V-SERIES HEAVY DUTY BROILERS, DOUBLE DECK AND RANGE MATCH MODELS - REMOVAL AND
NOTE: Leave the burner support screws installed.
The burner support is necessary to hold the burners
in place during removal procedure.
Fig. 15
8.
Remove screws [1] Fig. 16 (qty 6) securing
burner support [2] Fig. 16 to broiler frame.
Fig. 16
9.
Reach underneath burner support to access the
support rails [1] Fig. 17 (qty 6) that hold the
ceramic bricks in place. Remove screws (qty 2)
Fig. 17 securing each support rail to the rear of
burner support. Top view shown in Fig. 17.
Fig. 17
10. Provide support for burners from inside the
cooking area by stacking two 2 x 4's
approximately 24" long onto the broiler grid.
Position 2 x 4's underneath the burners near the
front.
REPLACEMENT OF PARTS
11. Adjust rack assembly to the middle position.
12. Remove cotter pin from all three burners.
13. Grasp the bottom of burner support in between
the burners and pull out on the burner support to
disengage burners. The front of burners will drop
down onto the 2 x 4's. Ensure the burner air
shutters are not catching in the burner support
opening to prevent removal.
14. Lift the burner being replaced off the rear pin and
pull toward the front to remove from broiler.
15. Remove burner support rails [1] Fig. 21 from
each side of burner [2] Fig. 21 being replaced.
Page 9 of 16
Fig. 18
Fig. 19
Fig. 20
F45548 (0715)
Advertisement
Table of Contents
