Table of Contents
Advertisement
S
ETUP
Power
Warning!
Verify that the power indicator label on your unit matches the line voltage applied.
All fixtures must be connected to circuits with a suitable Earth Ground.
To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture's specifications chart.
A fixture's listed current rating is its average current draw under normal conditions.
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
Before applying power to a fixture, check that the source voltage matches the fixture's
requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.
Po w e r Ca bl e Conf igu ra t io n
C
ABLE
B
ROWN
B
LUE
Y
ELLOW
Mounting (MIST-PAR80)
O ri en t at ion
This fixture can be mounted on a truss using a clamp in any position
or on a strut system for track style lighting.
Rigg ing
The fixture includes a mounting yoke to which 1 rigging clamp can be bolted.
1. Align the clamp screw with the center hole on the yoke and tighten.
2. Verify the structure can hold 10 times the weight of all to-be installed fixtures.
3. Adjust the angle on the yoke arm as necessary.
Mounting (MIST-PAN)
The COLORmist™ Panel can be
surface mounted directly using its
fastening hinge located directly behind
the unit or utilizing the surface
mounting bracket especially made to
fit. The bracket can be surface
mounted first then later the panel can
be mounted onto the bracket.
COLORmist™ System User Manual
P
I
IN
NTERNATIONAL
Live
Neutral
/G
Earth
EG (Ground)
REEN
L
N
Mounting
Bracket
6
Operating Instructions
Hanging Clamp
2005-10-10/18:36
Advertisement
Table of Contents
