Table of Contents
Advertisement
O
PERATING
Control Panel
On the control panel you can set the controller for single action mode where preset programs are run
either statically, automatically or by sound-activation or assign a starting DMX channel address.
MENU
Menu Diagram
System Setup
You will need to let the controller be aware of the number of par cans and/or panels connected in
series. This is essential in order for the chase and flow programs to perform correctly through out the
entire stretch of fixtures.
M System Setup
Init ia l S et u p
1. Press the MODE button until the display shows "M System Setup".
2. Press the SETUP button then the UP button once. It will show "3 Lamp Amount".
3. Press the SETUP button to enter the function. A number will now appear to the right of the text as
shown here in an example. "3 Lamp Amount 34".
4. Use the UP and DOWN buttons to locate a number between 0 and 250. This represents the
number of fixtures connected.
5. Press the MODE button to set this function.
Re- in it i al iz a t ion
Whenever a fixture is removed, replaced or exchanged please follow the following instructions.
1. Press the MODE button until the display shows "M System Setup".
2. Press the SETUP button then the UP button twice. It will show "2 Set Address".
3. Press the SETUP button to re-initialize.
4. Proceed to prior instruction "Initial Setup" and re-do.
COLORmist™ System User Manual
I
NSTRUCTIONS
[MENU] Returns to Main menu or step backward through functions
[SET UP] Enters menu selection
[UP] Steps backward through menu selection
[DOWN] Steps forward through menu selection
SETUP
UP
DOWN
1 DMX Ch
(0 – 508)
2 Set Address (N / A)
3 Lamp Amount (0 – 250)
Main Menu
For a detailed listing of Single
Action programs proceed to the
next page.
7
M Single Action
2005-10-10/18:36
Advertisement
Table of Contents
