Table of Contents
Advertisement
1.1.3
Indications on the LCD
Below are all the indications which appear on the standby display on the
transceiver unit.
Reference no.
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
⑬
⑭
*: If no MMSI is registered, the message "DSC NOT USABLE" appears.
INTL
1
4
Hi
5
RX
7
6
14
AUTO ACK
9
°
LAT: 34 45' N
°
LON: 135 45' E
Standby display on the transceiver unit
Displays the channel mode.
(INTL / USA / WX / CANADA / INLND-WA / (MEMO))
SHIFT is displayed if the shift function is active. Or memory number (for
example MEMO 01) is displayed at the MEMO mode.
Displays the scan mode: SCAN, DUAL or no display. During the scan
mode, channel indications are changed alternatively. No display means
that the unit receives continuously on the same channel.
Lights when the loudspeaker is off. Goes off when the loudspeaker is on.
Displays the transmission output.
(Hi=25W / Lo=1W)
Displays reception signal strength by 4 steps.
1. No signal. Only antenna mark is displayed.
2. Less than 37.6 dB (-100.6 dBm) SINAD：antenna mark and short bar
3. 40.0 dB (-96.9 dBm) SINAD and more：antenna mark and two bars
4. 41.9 dB (-92.9 dBm) SINAD and more：antenna mark and three bars
RX is displayed during reception and TX is displayed when
the RF signal detected at transmission state.
Displays the current channel.
（PRIV channel: max three digits）
Is displayed when the DSC routine call is received.
AUTO ACK: Automatic acknowledge
MANUAL ACK: Manual acknowledge
WATCH CH70 or WATCH VHF is selected at menu.
If the CH70 board is defective, WATCH CH70 NG appears.
Displays the longitude and latitude of own ship.
Displays UTC time.
Displays AUTO for automatic data input (L/L, time data) from a navigation
device or MANUAL for manual data input.
Displays when un-read message(s) exist.
1. OPERATIONAL OVERVIEW
116
DUP
8
WATCH CH70 *
10
10:45 UTC
11
AUTO
meaning
SHIFT
2
SCAN
3
12
13
1-5
Advertisement
Table of Contents
