Gigabyte GA-7VT600 1394 User Manual page 60

Set Supervisor/User Password
CMOS Setup Utility-Copyright (C) 1984-2003 Award Software
}Standard CMOS Features
}Advanced BIOS Features
}Integrated Peripherals
}Power Management Setup
}PnP/PCI Configurations
Enter Password:
Figure 11: Load Fail-Safe Defaults
}PC Health Status
}Frequency/Voltage Control
ESC:Quit
F8:Dual BIOS /Q-Flash
When you select this function, the following message will appear at the center of the screen to assist you
in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords: a SUPERVISOR PASS-
WORD and a USER PASSWORD. When disabled, anyone may access all BIOS Setup program
function. When enabled, the Supervisor password is required for entering the BIOS Setup program and
having full configuration fields, the User password is required to access only basic items.
If you select " System" at " Security Option" in Advance BIOS Features Menu, you will be prompted for
the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select " Setup" at " Security Option" in Advance BIOS Features Menu, you will be prompted only
when you try to enter Setup.
7VT600 1394 Motherboard
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
higf: Select Item
F10:Save & Exit Setup
Change/Set/Disable Password
Figure 11: Password Setting
- 56 -