Brinkmann 810-1750-S Installation Manual page 21

Cover Bolts
Retaining Nut
Existing Rotisserie LP
Replacement Rotisserie
Natural Gas Orifice
(identified by number)
Rotisserie Burner 1.35 mm (RED)
Brass Orifice
Gas Orifice
810-8533-S ROTISSERIE BURNER
CAUTION: Only use specified natural gas
orifice for your grill.
Note: It is helpful to keep the screws with
the components as they are removed
for ease of reassembly.
Step 10
Remove the three screws from front side of grill
to gain access to the rotisserie LP gas orifice on
back side of grill. Set aside for later use.
Step 11
Using an adjustable wrench to hold the gas line
secure, use the open end wrench provided to
loosening the gas line retaining nut. With the
rotisserie gas supply line detached from the
housing, use two wrenches to remove the LP
brass orifice from the gas supply line. Replace
the LP gas brass orifice with the proper natural
gas orifice. (1.35 mm RED)
Note: Bending the hose could damage the
supply line.
Step 12
Reattach gas supply line to the rotisserie
housing by securing with the retaining nut
removed in Step 11.
Note: Leave the back panel off until the end
of conversion and all gas leak testing
has been completed.
Step 13
Re-install rotisserie cover using the bolts that
were set aside in Step 10.
Note: Follow directions in the leak testing
section of this manual before using
this grill.
20