Brinkmann 810-1750-S Installation Manual page 11

Tab
Figure 1
Tab
Figure 3
Stop Plate
Stop Pin
Figure 2
Stop Plate
Stop Pin
Warming Rack
Cooking Grills
Heat Shields
Step 7
Figure 1 shows valve stem and bezel with the
control knob removed. Take six large stop
plates from the component card and place
them over the valve stems as illustrated (Figure
2). Take the small stop plate from the
component card and place it over the smoker
and rotisserie burner valve stem (Figure
3).Verify the tab and the stamped letter on the
stop plates face out. Replace control knobs
when finished.
WARNING: We recommend and request that
you do not remove the control panel in order
to access the valve tips. If you choose to
remove the control panel, you must replace
the control panel bezels exactly as illustrated
in Figure 2. Failure to replace the bezels as
illustrated could lead to personal injury and/or
property damage.
Step 8
Carefully replace each burner, making sure
burner openings slide over valve nozzles.
Screw each main burner "foot" down using
screwdriver and screws that were set aside in
Step 4. Replace screws and side burner that
were set aside in Step 2.
Step 9
Replace warming rack, cooking grills, heat
shields and grease tray.
Note: Follow directions in the leak testing
section of this manual before using
this grill.
10