Mounting - La Crosse Technology WT-5442U Instruction Manual

IV. MOUNTING THE REMOTE TEMPERATURE TRANSMITTER
A. The Remote Temperature Transmitter can be mounted in two ways: 1)
with the use of screws, or 2) using the adhesive tape.
B. MOUNTING WITH SCREWS
1. Remove the mounting bracket from the Remote Temperature
Transmitter. The bracket should snap off easily.
2. Place the mounting bracket over the desired location. Through the
three screw holes of the bracket, mark the mounting surface with a
pencil.
3. Where marked, start the screw holes into the mounting surface.
4. Screw mounting bracket onto the mounting surface. Ensure that the
screws are flush with the bracket.
5. Snap the Remote Temperature Transmitter onto the mounted
bracket.
C. MOUNTING WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the back of the mounting
bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
2. Remove the protective strip from one side of the tape. Adhere the
tape to the designated area on the back of the mounting bracket.
Remove the protective strip from the other side of the tape. Position
the Remote Temperature Transmitter in the desired location,
ensuring that the Weather Temperature Station can receive the
signal.
The weather icons change when the unit detects a change in air
pressure. The icons change in order, from "sunny" to "partly
sunny" to "cloudy" or the reverse. It will not change from "sunny"
directly to "rainy", although it is possible for the change to occur
quickly. If the symbols do not change then the weather has not
changed, or the change has been slow and gradual.
14