Infrastructure Mode - Ricoh C7528 Maintenance Manual

Troubleshooting
Possible cause
When you use IEEE 1394
interface board.
How is the signal strength
when using the wireless
LAN?
How is the signal strength
when using Bluetooth?
A
Check the IEEE 1394 interface board is attached to the com-
puter correctly.
B
Check the IEEE 1394 interface cable is connected securely.
C
Restart the computer.
If the error occurs even after executing the above, proceed to
the following steps.
D
Unplug the IEEE 1394 interface cable connected to the printer.
E
Execute the utility tool for IEEE 1394 interface board is stored
in the following path on the CD-ROM labeled "Printer Drivers
and Utilities".
UTILITY\1394
❒ For details about using the utility tool for IEEE 1394, see the
README file in the same directory on the CD-ROM.
❖ Ad Hoc Mode or 802.11 Ad Hoc Mode
Either move to a location where the signal is good or remove
obstructions.

❖ Infrastructure Mode

Check the signal status from the "Maintenance" menu on the
control panel. If the signal is poor, either move to a location
where it is good or remove obstructions.
Try the following:
• Check that the Bluetooth interface unit is installed properly.
• Check that there are no obstructions between the computer,
printer, and other devices.
• Change the location of the computer.
• Change the location of the printer.
Solutions
109