Ricoh C7528 Maintenance Manual page 106

Troubleshooting
Messages
/ Second messages
Reset Fusing
Unit correctly
Reset PCU
correctly
XXX/XXX
Reset the Job
or Form Feed
/ Paper Size:
Paper Type:
Reset Tray #
or Form Feed
Reset Waste
Toner correctly
Resetting Job...
ROM Update
Waiting for Data
ROM Update
Receiving Data
SC XXX-X
Power Off On
If Error Reoccur
Call Service
SD authenticatn.
failed
Setting change in
process
SSID not entered
Supply order
failed
Toner is almost
empty: Black
Description
There is no fusing unit, or the
fusing unit is not installed cor-
rectly.
The indicated photoconductor
unit(s) is/are not set correctly,
or not set.
XXX: Yellow/Magenta/Cy-
an/Black
The paper size and type setting
in the tray differs from that of
actual paper size and type in
the tray.
The indicated paper input tray
is not set correctly, or not set.
#: tray number
The waste toner bottle is not set
correctly, or not set.
Job is being reset.
The printer is waiting for updat-
ed data.
The printer is receiving updated
data.
Turn the power off and then on.
If the message appears again,
contact your sales or service
representative.
Authentication for the SD card
has failed.
The settings are being
changed.
This message appears if the
SSID has not been entered.
Supply order has failed.
The printer is almost out of ton-
er (K).
Solution
Set the fusing unit correctly.
See p.58 "Replacing the Fusing
Set the indicated photoconductor
unit(s) correctly.
See p.45 "Replacing the Photocon-
ductor Unit".
Load paper of the selected size in the
tray, and then change the paper size
setting with the control panel. Or,
press {Form Feed}, and then select the
tray using the control panel. Or, press
{Job Reset} to cancel the print job.
Set the indicated paper input tray cor-
rectly.
Set the waste toner bottle correctly.
Wait a while.
Don't turn off the printer while it is wait-
ing for data.
Don't turn off the printer while it is re-
ceiving data.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Turn the power switch off and then
back on again. If the message ap-
pears again, contact your sales or ser-
vice representative.
Wait a while.
Enter the SSID.
The use is required to reset the job.
Prepare a replace the toner cartridge
(K).
Unit".
106