Ricoh C7528 Maintenance Manual page 99

Troubleshooting
Messages
/ Second messages
Empty Punch Recep-
tacle
Energy Save Mode
Error: Enter 10
or 26 characters
Error: Enter 5
or 13 characters
Error: Tray #
Form Feed
/ Or Job Reset
Then Power OffOn
Exceeded Max.
Pages (Collate)
Exceeded Max.
Stored Files
Exceeded Max.
Stored Pages
Hardware Problem
Ethernet
Hardware Problem
Finisher
Description
The Punch Chips container is
full of punch chips.
In Energy Save Mode level 2.
An ID with an invalid number of
digits was entered for the WEP
key.
An ID with an invalid number of
digits was entered for the WEP
key.
The printer identified the failure
of the indicated paper tray. The
job is not printed.
#: tray number
The printer identified a collation
page overflow error.
The maximum number of
stored files has been exceeded
during Sample Print of Locked
Print.
The maximum number of pag-
es has been exceeded during
Sample Print of Locked Print.
The printer identified an Ether-
net error.
There is a problem with the fin-
isher.
Solution
Empty the punch waste box.
See p.134 "Removing Punch-hole
Chips".
If the message appears the punch
waste box is not full, remove the
Punch-hole chips on the top of the
punch waste box.
See p.134 "Removing Punch-hole
Chips".
No action required.
Enter the correct number of digits for
the WEP key.
Enter the correct number of digits for
the WEP key.
Apply Form Feed from another tray or
cancel the job, and then switch your
printer Off, then back On. If the error
continues, contact your sales or ser-
vice representative.
Add extra RAM.
Install the optional hard disk drive.
Delete stored files.
Reduce the number of pages to print.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Turn the power off, and then on. Re-
move and re-install the finisher cor-
rectly. If the message appears again,
contact your sales or service repre-
sentative.
See p.37 "Detaching and Reattaching
the Options".
99