Screensaver (For Preventing Image Retention) - Panasonic TH-49AF1U Operating Instructions Manual

Screensaver
(For preventing image retention)
Do not display a still picture, especially in 4:3 mode, for
any length of time.
If the display must remain on, a Screensaver should be
used.
[Screensaver] - submenu screen
Screensaver
2016/01/01
Start
Mode
■
Screensaver settings
Screensaver operation
When the Screensaver is operating, the following 5
patterns are displayed full screen for 5 seconds each,
and it will be repeated.
Black → Dark grey → Grey → Light grey → White →
Light grey → Grey → Dark grey
To start Screensaver now
Select [On] in [Mode].
Select [Start] and press <ENTER>.
●
The Screensaver will be activated.
Screensaver
2016/01/01
Start
Mode
Note
●
If the following buttons are pressed while the
screen saver is operating, the screen saver is
cancelled.
Remote control: <RETURN>
Main unit: <MENU (Unit)> <INPUT (Unit)>
<+ (Unit)> <- (Unit)>
<ENTER (Unit)>
●
When the display is turned off, the Screensaver will
be deactivated.
To set interval of Screensaver
Select [Interval] in [Mode].
Set [Periodic time].
●
Press to change the time by 15 minutes.
●
In [ENGLISH(US)] OSD language, [Periodic
time] is displayed as [SHOW DURATION].
Set [Operating time].
●
Press once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
● In [ENGLISH(US)] OSD language, [Operating
time] is displayed as [SAVER DURATION].
FRIDAY 10:00
Off
FRIDAY 10:00
On
Screensaver
2016/01/01
Start
Mode
Periodic time
Operating time
Periodic time
Deactivated.
Note
●
It is not possible to set the duration of [Operating
time] longer than that of [Periodic time].
To set start and finish time of Screensaver
Select [Time designation] in [Mode].
Set [Start time] and [Finish time].
●
Press once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
●
In [ENGLISH(US)] OSD language, [Time
designation] is displayed as [TIME OF DAY].
Screensaver
2016/01/01
Start
Mode Time designation
Start time
Finish time
Note
● Please set [Date & time] in OpenPort PLATFORM
before setting [Start time] and [Finish time]. (see
page 59)
●
This can be set only when the date is 2016/01/01
and after.
●
The screen saver of [Time designation] may not
operate depending on the status, such as when the
OpenPort PLATFORM system is restarting.
To turn the power off after Screensaver
Select [Standby after SCR saver] in [Mode].
Set [Screensaver duration].
● Press once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
Select [Start] and press <ENTER>.
● Screensaver will be activated and the power will
be turned off (standby) at the time set.
Screensaver
2016/01/01
Start
Mode Standby after SCR saver
Screensaver duration
FRIDAY 10:00
Interval
0:00
0:00
Operating time
FRIDAY 10:00
0:00
0:00
FRIDAY 10:00
0:00
English
81