Administrator Tools; Onine Settings - Gestetner CP6143L Operating Instructions Manual

C2678608_Platinum-EN.book Page 108 Sunday, February 12, 2006 10:53 PM
User Tools

6 Administrator Tools

❖ User Codes
If user codes are turned on, operators must enter their user codes before they can operate
the machine. The machine keeps count of the number of masters and prints made under
each user code. See "3 Set User Code" below.
1 Display Counter(s)
2 Clear Counter(s)
3 User Code
Management
5
4 Key Counter Adjust Normally, the optional key counter counts the number of prints

7 Onine Settings

Limitation
❒ The optional PC controller is required.
No. Mode
1 Hold Data-in
108
You can check the number of masters and copies made under
each user code.
You can clear each or all user code counters.
Reference
To clear the number of masters and copies, see p.110 "Clear-
ing the Counter".
You can select whether or not to use User Code mode.
Note
❒ Default: Do not Use
regardless of the number of masters used. You can, however,
add to the key counter a value between 0 and 50 to the key
counter each time a new master is used.
Note
❒ Default: 0 time
❒ Range of adjustment: 0–50
Description
You can select to have Hold Data-in mode either "On" or "Off"
when the power is turned on, or after mode settings have been
cleared.
Note
❒ Default: Off