Table of Contents
Advertisement
Displaying Dual Pictures
Picture in Picture function allows you to display two pictures on the same screen. You can
display the image input from INPUT 3 or 4 as an inset picture overlapping the main picture
from INPUT 1 or 2.
Displaying the Inset Picture
1
Press
.
2
Press
or
control or
to switch the image in the in-
set picture .
3
' '
' ' , "
" "
" " , \ \ \ \ \ and | | | | | to set the
Press '
position of the inset picture.
• Press
to stop the frame from mov-
ing or to make the frame disappear.
4
Press
to move the inset pic-
ture.
• The inset picture will be moved to the
inset picture frame.
Note
• The inset picture can only be displayed
with composite video (NTSC/PAL/
SECAM) or S-Video signal.
• The Freeze function works only with the
inset picture, when the Pict in Pict mode
is in operation.
When the signal entered into INPUT 1 or 2
is as follows, Pict in Pict does not work:
• With a resolution that exceeds SXGA.
• When the input signal is 480
I,
540P, 580
580P, 720P, 1035
• When the input signal has changed to
the Interlace mode using RGB signals.
• When the picture display mode is set to
"DOT BY DOT".
• When no signals are sent to INPUT 1 or
2, or when the resolution or refresh rate
(vertical frequency) is changed.
on the remote
on the projector
I
, 480P,
I
I
or 1080
.
(Pict in
Pict)
UNDO button
ENTER button
'
"
\
|
,
,
,
buttons
PinP button
INPUT 3/4 buttons
-57
Advertisement
Table of Contents
