Table of Contents
Advertisement
3
Press
,
,
the remote control to select the
INPUT mode.
• After pressing
once on the projector,
use
to select the desired input mode.
Note
•When no signal is received, "NO
SIGNAL."will be displayed. When a
signal that the projector is not pre-
set to receive is received, "NOT
REG." will be displayed.
• When "Auto Search" is "ON", the
INPUT modes with signals can be
selected. (see page 64.)
• The INPUT mode is not displayed
when "OSD display" is set to "Level
A" or "Level B". (see page 65.)
About the INPUT modes
INPUT 1
Used for projecting im-
INPUT 2
ages from equipment that
(RGB/
sends RGB signals or
Component)
component signals con-
nected to the RGB input
terminal.
INPUT 3
Used for projecting im-
(Video)
ages from equipment
connected to the VIDEO
input terminal.
INPUT 4
Used for projecting im-
(S-Video)
ages from equipment
connected to the S-
VIDEO input terminal.
4
Press
or
control to adjust the volume.
Note
• Pressing
will lower the volume.
Pressing
will raise the volume.
• On the projector, the volume can be
adjusted by pressing
•
,
on the projector operate
as cursor buttons (\, |) when the
menu screen is active.
or
on
on the remote
or
.
"On-screen Display (Example)
INPUT 1 mode
Using RGB
Using
Component
INPUT 2 mode
Using RGB
Using
Component
INPUT 3 mode
Using Video
INPUT 4 mode
Using S-Video
VOLUME
buttons
-35
Advertisement
Table of Contents
