Onkyo TX-RZ820 Basic Manual page 62

> Specifications > Advanced Setup
Setting Item Default Value
Power On Volume Last
■ 3� Remote Play Zone
Setting Item Default Value
Remote Play Auto
Zone
26
> Listening Modes
Setting Details
Set the Zone 3 volume level of when this unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned off), "Min", "0.5" to "99.5"
and "Max". (When "3. Audio Adjust" - "Volume" -
"Volume Display" is set to "Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Setting Details
When playing using AirPlay or Spotify Connect,
or when using the Music Server feature to play
remotely from your PC, you can set whether to
play in the main room (where this unit is) or in a
separate room (ZONE 2/ZONE 3).
"Auto": When the main room input selector is
NET, music is played in the main room. When the
separate room input selector is NET and the main
room is other than NET, then the music is played in
the separate room.
"Main", "Zone 2", "Zone 3": Select when limiting the
play zone to a particular room. For example, when
playing only in the separate room, select "Zone 2"
or "Zone 3".
• This feature may not work if something is
already being played with the same network
feature.
> Network Functions
7� Miscellaneous
Change the frequency step for the tuner, update the firmware, and perform Initial Setup,
etc.
■ 1� Tuner
Setting Item Default Value
AM / FM 10 kHz / 0.2 MHz Select a frequency step depending on your area of
Frequency Step
(North American
models)
AM Frequency 9 kHz
Step (European
and Asian
models)
■ 2� Remote ID
Setting Item Default Value
Remote ID 1
> Basic Manual
Troubleshooting Supplementary Information, etc� |
Setting Details
residence.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets
are deleted.
Select a frequency step depending on your area of
residence.
Select "10 kHz" or "9 kHz".
• When this setting is changed, all radio presets
are deleted.
Setting Details
Select an ID for the unit's remote controller from
"1", "2", and "3" to prevent interference between
the unit and other ONKYO components that are
installed in the same room. After changing the ID
on the main unit, change the ID on the remote
controller accordingly with the following procedure.
While holding down MODE, press the following
buttons for about 3 seconds.
• To change the remote controller ID to "1":
(The remote indicator flashes once.)
• To change the remote controller ID to "2":
(The remote indicator flashes twice.)
• To change the remote controller ID to "3":
(The remote indicator flashes three times.)