Table of Contents
Advertisement
> Before Start
> Part Names
Step2: Connect the Speakers
a
a Speaker cable, b Subwoofer cable
14
> Install
> Initial Setup
1/2˝
(12 mm)
b
> Playback
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
Standard Connections (Pages 8 to 11)
Connect 12345678 for a 7.1 channel system. Connect
1234569: for a 5.1.2 channel system. Up to two
powered subwoofers can be connected. The same signal is
output from each of the SUBWOOFER PRE OUT jacks.
0 You can also connect both 78 and 9:. However, you
can only output audio from one of these at a time. When
both are connected, you can switch which speakers to
prioritize. Press Q on the remote control (P6) and use
"Other" - "Speaker Layout" to switch between surround
back speakers and height speakers.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P24).
0 If any of the connected speakers have an impedance
of 4 Ω or more to less than 6 Ω, after completing
Initial Setup, you need to make some settings in the
Setup menu. Press
select "2. Speaker" - "Configuration" and set
"Speaker Impedance" to "4ohms".
Make sure the exposed wires of the speakers do
not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers
touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
on the remote controller,
Advertisement
Chapters
Table of Contents
