Onkyo TX-RZ820 Basic Manual page 49

> Specifications > Advanced Setup
Setting Item Default Value
Surround 80Hz(THX)
Surround Back 80Hz(THX)
LPF of LFE 120Hz
Double Bass On
> Listening Modes
Setting Details
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when
"Surround" is set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set the low-pass filter for LFE (low-frequency
effect) signals in order to pass lower frequency
signals than the set value and thus cancel
unwanted noises. The low-pass filter will be
effective only on sources with LFE channel.
The value from "80Hz" to "120Hz" can be set.
"Off": When this function is not to be used
This can be selected only when "Configuration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Full Band".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
• The setting will not automatically be configured
even if you performed AccuEQ Room
Calibration.
> Network Functions
■ 3� Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value
Front Left 12.0ft/3.60m
Center 12.0ft/3.60m
Front Right 12.0ft/3.60m
Height Left 9.0ft/2.70m
Height Right 9.0ft/2.70m
Surround Right 7.0ft/2.10m
Surr Back Right 7.0ft/2.10m
Surr Back Left 7.0ft/2.10m
Surround Left 7.0ft/2.10m
Subwoofer 12.0ft/3.60m
• Default values vary depending on the regions.
> Basic Manual
Troubleshooting Supplementary Information, etc� |
Setting Details
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if anything
other than "No" is set in "Configuration" - "Zone
Speaker" and Zone 2 is on.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if anything
other than "No" is set in "Configuration" - "Zone
Speaker" and Zone 2 is on.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if anything
other than "No" is set in "Configuration" - "Zone
Speaker" and Zone 2 is on.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if anything
other than "No" is set in "Configuration" - "Zone
Speaker" and Zone 2 is on.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
13