Onkyo TX-RZ820 Basic Manual page 32

> Before Start > Part Names
0 The information for a connected
device can be displayed on the TV
screen in a separate room. Press the
button while the remote controller
is in the mode for controlling ZONE 2.
To turn off the function:
Press Í while in the mode for controlling
ZONE 2 or ZONE 3 on the remote
controller.
Playing in ZONE 2 or ZONE 3 only:
If you turn the unit to standby during multi-
zone playback, the Z2 or Z3 indicator is
dimmed and the playback mode is
switched to playback in a separate room
only. Setting ZONE 2/ZONE 3 to on while
this unit is in standby will also switch the
playback mode to the same setting.
WHOLE HOUSE MODE
If you press WHOLE HOUSE MODE while
playback is being performed in the main
room, the WHOLE HOUSE MODE is
turned on, "Z2" and "Z3" on the display light
at the same time and the playback sources
of all the rooms are switched to the same
source at once.
0 The sources that can be played in ZONE
2 can be played in all rooms.
0 This function cannot be used if
headphones are connected or audio is
output from the speakers of the TV.
32
> Install > Initial Setup
To return the remote controller
to main room control mode:
While holding down MODE on the
remote controller, press MAIN (c)
for 3 seconds or more until the
remote indicator flashes once.
> Playback > Advanced Manual
Troubleshooting | Supplementary Information, etc.