Onkyo TX-RZ820 Basic Manual page 48

> Specifications > Advanced Setup
Setting Item Default Value
Zone Speaker No
Bi-Amp No
Speaker 6ohms
Impedance
12
> Listening Modes
Setting Details
Set the connection of speakers to Zone 2 speaker
terminals.
• This setting cannot be selected when surround
back speakers and height speakers are
installed.
"Zone 2": When speakers are connected to Zone
2 speaker terminals (ZONE 2A for North American
models)
"Zone 2A+B" (North American models): When
speakers are connected to Zone 2A and Zone 2B
speaker terminals
• This setting cannot be selected when height
speakers are installed.
"No": When speakers are not connected to Zone 2
speaker terminals
Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• This item will be fixed to "No" when anything
other than "No" is selected for the "Zone
Speaker".
• This setting cannot be selected when surround
back speakers or height speakers are installed.
Set the impedance (Ω) of the connected speakers.
"4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6ohms": When the connected speakers all have
6 Ω or more impedance.
• For impedance, check the indications on the
back of the speakers or their instruction manual.
> Network Functions
■ 2� Crossover
• If you are using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz" in "LPF of LFE".
– Set a value "Off" in "Double Bass".
Setting Item Default Value
Front 80Hz(THX)
Center 80Hz(THX)
Height 80Hz(THX)
> Basic Manual
Troubleshooting Supplementary Information, etc� |
Setting Details
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be
output from the front speakers. Refer to the
instruction manual of your speakers to make the
setting.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.