Dell EMC E39S Series Installation And Service Manual page 56

Viewing Network Settings
To view the Network Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Network Settings.
Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option Description
UEFI PXE Settings
Options
PXE Device n (n =
1 to 4)
PXE Device n Enables you to control the configuration of the PXE device.
Settings(n = 1 to
4)
UEFI HTTP
Options
Settings
HTTP Device (n =
1 to 4)
HTTP Device n Enables you to control the configuration of the HTTP device.
Settings (n = 1 to
4)
UEFI iSCSI Enables you to control the configuration of the iSCSI device.
Settings
56 Pre-operating system management applications
Description
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the
device.
Description
Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the
device.
Table 41. HTTP Device n Settings screen details
Option
Interface
Protocol
VLAN
VLAN ID
VLAN Priority
URI (will obtain from DHCP server if not specified)
Description
Specifies the NIC interface used for this device.
Enables you to select protocol IPv4 or IPv6. This is
set to IPv4 by default.
Enables or Disable VLAN. This is set to Disabled by
default.
This is set to 1.
This is set to 0.