Built-In Needle Threader - Janome Memory Craft 6650 Instruction Book

z
q
x
c
v
n
w
e
r
b

Built-in Needle Threader

NOTE:
• The needle threader can be used with a #11 to #16
needle.
Thread size 50 to 90 is recommended.
Do not use thread size 30 or thicker.
• The needle threader cannot be used with the twin
needle.
z Press the needle up/down key to raise the needle.
Press the lockout key to lock the machine.
q Needle up/down key
w Lockout key
x Draw the thread through the slit e of the needle
threader. The thread should pass under the hook r.
e Slit
r Hook
c Pull the thread up and slip it between the thread cutter
and face plate from behind.
Pull the thread toward you to cut.
v Pull down the needle threader lever as far as it will go.
b Raise the threader slowly so a loop of the thread is
pulled up through the needle eye.
n Pull the thread loop to take the thread end out through
the needle eye to the rear.
NOTE:
If the thread is caught in the hook and the thread loop
is not formed, remove the thread from the hook and
pull it to take the thread end out through the needle
eye.
24