Built-In Needle Threader - Janome C30 Instruction Book

z
w
q
x
c
v
e
r
t

Built-in Needle Threader

CAUTION:
Turn off the power switch when using the needle
threader.
NOTE:
The needle threader can be used with a #11 to #16
needle or a blue tip needle. Thread sizes 50 to 90 are
recommended.
z Press the needle up/down button to raise the needle
to its highest position.
Turn the power switch off.
Pull down the needle threader knob as far as it will go.
q Needle up/down button
w Threader knob
x Turn the knob in the direction of the arrow in the
illustration, then insert the hook into the needle eye.
Lead the thread around the guide and under the hook.
e Hook
r Guide
c Turn the knob in the direction of the arrow in the
illustration, drawing the thread loop through the
needle.
Gently let the needle threader goes up to pull the
thread loop up.
t Thread loop
v Pull the thread through the needle eye.
18