Built-In Needle Threader - Janome Sewist 740DC Instruction Book

z
w
x c
x
r e
v
b
q
e
c
t
t
y

Built-in Needle Threader

CAUTION:
Turn off the power switch when using the needle
threader.
NOTE:
The needle threader can be used with a #11 to #16
needle or a blue tip needle. Thread sizes 50 to 90 are
recommended.
z Press the needle up/down button q to raise the
needle to its highest position.
Turn the power switch off.
Pull down the needle threader knob as far as it will
go. The hook comes out through the needle eye from
behind.
q Needle up/down button
w Knob
e Hook
x Draw the thread from the left guide to the right guide
and under the hook.
r Left guide
t Right guide
c Draw the thread to the front along the right side of the
right guide.
v Raise the knob in the direction of the arrow, drawing
the thread loop through the needle.
y Thread loop
b Pull the thread through the needle eye.
NOTE:
If the thread is caught in the hook and the thread loop
is not formed, remove the thread from the hook and
pull it to take the thread end out through the needle
eye.
22