TP-Link TL-WR940N User Manual page 64

Chapter 4
• DHCPv6 - Connections which use dynamic IPv6 address assignment.
• Static IPv6
• PPPoEv6 - Connections which use PPPoEV6 that requires a username and
password.
• Tunnel 6to4
SLAAC
• IPv6 Address
• IPv6 Address Prefix
provided by your ISP.
• Default Gateway
provided by your ISP.
• Connect - Click
• Disconnect
• Get IPv6 DNS Server Automatically
address, keep the default selection
DNS servers will be assigned from ISP dynamically.
• Primary IPv6 DNS
notation provided by your ISP.
• Secondary IPv6 DNS
hexadecimal notation provided by your ISP.
• Use the following IPv6 DNS Servers
addresses, select
IPv6 DNS and
Note:
If you get "Address not found error" when you access a web site, it is likely that your DNS servers are set up
improperly. You should contact your ISP to get DNS server addresses.
- Connections which use static IPv6 address assignment.
- Connections which use 6to4 address assignment.
- The IPv6 address assigned by your ISP dynamically.
- Display the IPv6 prefix length in dotted-decimal notation
- Display the default gateway in colon-hexadecimal notation
Connect to connect immediately.
- Click Disconnect
- Enter the DNS IPv6 address in colon-hexadecimal
- Enter another DNS IPv6 address
Use the following IPv6 DNS Servers
Secondary IPv6 DNS
to disconnect immediately.
- If your ISP does not give you any DNS IPv6
Get IPv6 DNS Server
- If your ISP gives you one or two DNS IPv6
in the corresponding fields.
Automatically, and the
in colon-
and enter the Primary
59