TP-Link TL-WR940N User Manual page 123

1 ) Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2 ) Go to Network
Tips:
• Some ISP may register the MAC address of your computer when you access the internet for the first time
through their Cable modem. If you add a router into your network to share your internet connection, the ISP will
not accept it as the MAC address is changed, so we need to clone your computer's MAC address to the router.
• The MAC addresses of a computer in wired connection and wireless connection are different.
• Modify the LAN IP address of the router.
Note:
Most TP-Link routers use 192.168.0.1/192.168.1.1 as their default LAN IP address, which may conflict with the
IP range of your existent ADSL modem/router. If so, the router is not able to communicate with your modem and
cause you can't access the internet. To resolve this problem, we need to change the LAN IP address of the router
to avoid such conflict, for example, 192.168.2.1.
1 ) Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2 ) Go to Network
3 ) Modify the LAN IP address as the follow picture shows. Here we take 192.168.2.1
as an example.
4 ) Click Save.
• Restart the modem and the router.
1 ) Power off your modem and the router, and leave them off for 1 minute.
2 ) Power on your modem first, and wait about 2 minutes.
3 ) Power on the router, and wait another 1 or 2 minutes and check the internet
access.
• Double check the Internet Connection Type.
> MAC Clone, select
> LAN.
Clone MAC Address and click Save.
118