Table of Contents
Advertisement
Answering system
Answering system settings
Number of rings
You can set the answering system to answer an incoming call after two, three,
four, five, or six rings. You can also select toll saver, which is explained below. By
default, the answering system answers an incoming call after four rings.
To set the number of rings:
1. Press
MENU
2. Press
or
CID
SELECT.
3. Press
or
CID
SELECT.
4. Press
or
CID
SELECT.
5. Press
or
CID
Toll saver.
Toll saver - the answering system answers a call after
f
two rings when you have new messages, or after four
rings when there is no new message. This feature
allows you to check for new messages and avoid
paying long distance charges when calling from out
of your local area.
SELECT
6. Press
Notes:
If you set the number of rings for the answering system as 2 or 3 rings, the caller ID announce feature may not have
f
enough time to announce the caller's full information.
If Smart call blocker is on, the first ring of all calls will be muted.
f
in idle mode.
to highlight Answering sys, then press
DIR
to highlight Ans sys setup, then press
DIR
to highlight # of rings, then press
DIR
to choose from 6, 5, 4, 3, 2 or
DIR
to save. You hear a confirmation tone.
146
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK
SELECT
# OF RINGS
6
5
4
BACK
SELECT
ANSWERING SYS
Cal l screening
# of rings
Remote code
BACK
SELECT
# OF RINGS
4
3
2
BACK
SELECT
Advertisement
Table of Contents
