Table of Contents
Advertisement
Connecting Motion / Alarm Device - Appendix #6
Motion detection and Alarm controls are enabled through the Menu system on the Observation
System. Additional motion sensor devices can be connected to the system (Motion Sensors,
Door/Window Sensors).
A motion detection or sensor unit can
be used to send a signal to the
Observation System to begin camera
viewing on the matching Video
Channel
(when
enabled
MENU/ALARM SET MODE)
• Example: A Window sensor unit
has been installed on Alarm
Block port #4. When this sensor
is activated, the camera on DIN
or BNC VIDEO port #4 will
become active (if enabled in the
MENU on the Observation
System)
For the corresponding Menu Pro-
gramming, refer to Page 26.
Installing a Sensor
1. Connect the GROUND Cable to the
GND port on the Alarm Block on the
Observation System
2
2. Connect the SIGNAL Cable to a
numbered port (1-8)
To start ALARM RECORDING on a
DVR unit, refer to the manual for
your specific DVR product.
in
the
1
Connecting Motion / Alarm Device - Appendix #6
OBSERVATION SYSTEM
SENSOR
(Not Included)
39
Advertisement
Table of Contents
