Connecting Motion / Alarm Device - Appendix #13; Installing A Sensor - Lorex L20WD800 Series Instruction Manual

Connecting Motion / Alarm Device - Appendix #13

Connecting Motion / Alarm Device - Appendix #13
Motion detection and Alarm controls are enabled through the Menu system on the System.
Additional motion sensor devices can be connected to the system (Motion Sensors, Door/
Window Sensors).
A motion detection or sensor unit can be used to send a signal to the System to begin camera
viewing on the matching Video Channel (when enabled in the Menu).
• Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor
is activated, the camera on DIN or BNC VIDEO port #4 will become active (if enabled in the
MENU on the System)

Installing a Sensor

1. Connect the GROUND Cable to the GND port on the Alarm Block on the System
2. Connect the SIGNAL Cable to a numbered port (1-8)
To start ALARM RECORDING on the System, configure the System Menu.
1-4 / 5-8: Alarm input terminals
receive a signal from a device (i.e.
Door or Window Sensor).
114
SYSTEM
SENSOR
(Not Included)
NO / NC: Alarm Output Terminals
Ground
send a signal to another device
when an alarm input is detected.