Fluke TiX620 User Manual page 71

A measuring point is initially created in the center of the
image and can be moved in the image area by using the

joystick . The "active" point is identified with a red
square in crosshairs as well as an identifier shaded in
gray. After the position of the point is reached, exit the
editor by pushing the  button: Thereafter, the red mark
on the point is no longer visible.
Note
While the measuring objects are being moved,
the measured value is not updated.
Shop for Fluke products online at:
Line L
The position of the measuring line can be defined by
moving one of the terminal points or by synchronously
moving both terminal points simultaneously. The
respective "active" point and/or both points are also
marked in red. If the  button is pressed in the editor, the
settings dialog for displaying the measured values is
shown. For surface areas and lines, the spot temperature
can be shown as values and as spot in the image, along
with the average value. Furthermore, the identifier of the
measuring object can be hidden and the (local) emissivity
for the measuring object can be set. A further line can be
created by pushing the  button without exiting the
dialog. The current line can be deleted within the dialog
by using the  button. The dialog is closed by pushing
the  button.
MyFlukeStore
www.
3
Display Menus
Measure Menu
3-27
1.888.610.7664
.com