Troubleshooting Guide - Razor E325 Owner's Manual

TROUBLESHOOTING GUIDE

Problem
Does not work out of the box
No longer works
Short ride time/runs slow
Runs intermittently
For more troubleshooting tips, a list of available replacement parts or to locate an authorized Service Center in your area,
visit our website at www.razor.com or call toll free 866-467-2967 to speak to a live Customer Service Representative
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
*Unit(s) should be turned off and fully charged prior to doing any Troubleshooting
NOTE: All troubleshooting steps should be performed by an adult only
Possible Cause
Loose connection(s)
Loose connection(s)
Charger not working
Tripped reset button
Battery will not hold a charge
Rider weight
Low tire pressure
Riding conditions
Battery not fully charged
Old/damaged battery
Improper battery maintenance
Brake is dragging
Loose connection(s)
Solution
Check for loose connections/wires.
Check for loose connections/wires.
Check power to wall outlet and/or try a different outlet
Check lights on charger:
Plugged into wall - Green
Plugged into wall & unit - Red (charging)
Plugged into wall & unit - Green (charging complete)
No lights/Blinking lights - Replace Charger
Secure unit; turn the power switch on and with no weight on the
unit, lift up back end and apply the throttle. If motor engages -
Replace Battery
The reset button will trip if the motor is overloaded. An excessive
overload may be caused, for example, by too heavy a rider, too
steep a hill, etc. Wait a few seconds then press reset button.
Correct riding conditions to prevent overload
If motor does not engage, but makes a clicking sound - Replace
battery. If motor does not engage, no clicking sound - Replace
Control Module
Do not exceed 220 lb (100 kg) maximum weight limit
Tires will lose some pressure over time.
Verify correct tire pressure
Use only on flat, dry surfaces. Avoid inclines and areas with
heavy debris
Charge unit for a minimum 12 hours
Secure unit; turn the power switch on and with no weight on the
unit, lift up back end and apply the throttle. If motor engages -
Replace Battery
Charge battery periodically when not in use
Do not store unit in freezing or below freezing temperatures.
Freezing will permanently damage the battery and greatly reduce
ride time. Refer to page 5 for charging information
Check the brake cable has 2-3 mm of slack at lever. Cables
should NOT be wrapped around the handlebar stem. Adjust brake
cable slack according to page 7 instructions
Check the wires around the throttle and connectors underneath
the deck plate for other possible loose connections.
Replace - twist-grip throttle.
10