Installing Ddr4 Memory; Dimm Installation; Removing Memory Modules - Supermicro Supero C7Q270-CB-ML User Manual

2-4 Installing DDR4 Memory

Note: Check the Supermicro website for recommended memory
modules.
Attention! Exercise extreme care when installing or removing
DIMM modules to prevent any possible damage.

DIMM Installation

1. Insert the desired number of
DIMMs into the memory slots,
starting with DIMMB2 (see the
next page for the location). For
the system to work properly,
please use the memory modules
of the same type and speed in
the same motherboard.
2. Align the DIMM module key
with the receptive point on the
single-latch DIMM slot.
3. Push the release tab outwards to
unlock the slot.
4. Align the notch on the end of the
module against the receptive point
on the end of the slot.
5. Press both ends of the module
straight down into the slot until the
module snaps into place.
6. Push the release tab to the lock
position to secure the module into
the slot.

Removing Memory Modules

Reverse the steps above to remove the
DIMM modules from the motherboard.
JPME2:
1-2:NORMAL
2-3:ME MANUFACTURING MODE
JL1:
CHASSIS
INTRUSION
B1
JBT1
JBT1:CMOS CLEAR
LED1
JSTBY1
CLEAR CMOS
RESET BUTTON POWER BUTTON
I-SATA4 I-SATA2 I-SATA0
I-SATA5 I-SATA3 I-SATA1
Receptive Point
Release Tab
2-9
Chapter 2: Installation
LAN
DVI
USB 4/5(3.0) HDMI/DP
HD AUDIO
USB 6/7(3.0)
JI2C1/JI2C2 JPUSB1:USB0/1 WAKE UP
ON :ENABLE 1-2 ENABLE
OFF:DISABLE
2-3 DISABLE
2280
2260
2242
CPU
BIOS LICENSE
PCIE M.2
CONNECTOR 1
JSTBY1:
5V STBY POWER
JPW1
SYS_FAN1
Module Key
Notch
Press both notches
straight down into
the memory slot.
KB/MOUSE
USB 0/1
JVR1
DIMMA1
DIMMA2
DIMMB1
DIMMB2