Using The Memory; Registering To Memory Channels - Yaesu FR5DR Operating Manual

Using the Memory

The FT5DR/DE transceiver incorporates a large number of memory channels that can
register the operating frequency, communication mode, and other operational information.
⿠900 Memory Channels
⿠99 Skip Search Memory Channels
⿠11 Home Channels
⿠50 pairs PMS Memory Channels
⿠Preset Receiver Memory Channels include the International VHF marine radio (57
channels) and Worldwide Wide Broadcasts (89 channels)
r With the memory auto grouping (MAG) function, memory channels only in the same
frequency band may be automatically recalled as a group.
The operating frequency and other operational information can be registered to each
regular memory channel, home channel, or PMS memory channel:
• Operating frequency
• Memory tag
• DCS information
• FM mode bandwidth
Memory channels can be sorted and registered into memory banks according to the in-
tended use. The transceiver allows using 24 types of memory banks. A maximum of 100
memory channels can be registered in each memory bank.
Back up the stored contents to a microSD memory card. For details on saving a
backup onto a microSD memory card, refer to the Advanced Manual which may be
downloaded from the Yaesu website.

Registering to Memory Channels

1. Set the frequency and the communication mode to be
registered to a memory channel.
2. Press and hold [V/M ● ] key.
The memory channel number blinks.
The memory channel number next to the previously
recalled memory channel is automatically selected.
3. Rotate the DIAL knob to select the desired channel
number.
• The channel number of a memory channel that has
already been written or deleted blinks in red.
• Touch [
], and rotate the DIAL knob to fast-for-
ward 10 channels at a time. Touch [
cancel fast-forward.
4. Press the [V/M ● ].
• If you attempt to register a frequency to a memo-
ry channel that already contains frequency data,
"OVERWRITE?" will appear on the LCD. Touch [OK]
twice to overwrite the memory channel.
• The memory tag input screen will be displayed on the LCD.
5. Input the memory tag.
If not entering a name tag → proceed to step 6.
30
• Operation Mode
• Repeater Shift
• ATT
• S meter squelch
Note
• Frequency Step
• TX/RX DG-ID
• Specified Memory Channel
• Memory channel skip information
] again, to
• Transmitter output
• Tone information