Acer Altos easyStore M2 User Manual page 241

If you're using the iSCSI protocol, by default SAN Disk Manager
•
uses the first detected iSCSI HBA to communicate with the
storage system. If no HBA is detected, the Microsoft iSCSI Initiator
is used by default. To change this setting, click the Advanced
button next to the iSCSI protocol, select the desired mechanism
from the list, and then click OK.
You can also click Advanced to specify the target portal IP
•
address and port number to use for communicating with the
storage system.
If the iSCSI initiator name does not end with :hostname or
•
:hostname.domainname (where hostname is the name of your
computer and domainname is the name of the domain to which
your computer belongs, if any), you are prompted to either use
the original initiator name, change the name (an acceptable
name is displayed automatically), or use the current name.
If you change the name, other iSCSI targets (including any virtual
•
disks that you are currently using) might not be accessible until
you reconfigure the client on the storage system.
219