Making Wi-Fi Direct (Simple Ap) Connection Settings - Epson ET2710 Series User Manual

User's Guide

Making Wi-Fi Direct (Simple AP) Connection Settings

This method allows you to connect the printer directly to devices without a wireless router. The printer acts as a
wireless router.
1. While holding down the
alternately.
Wait until the process ends.
When a connection is established, the
Note:
If you enable Wi-Fi Direct once, it remains enabled unless you restore the default network settings.
2. Load papers.
3. Hold down the button on the printer for at least seven seconds.
The network status sheet is printed. You can check the SSID and Password for Wi-Fi Direct (Simple AP) on
this sheet.
Note:
If you release the
Password for Wi-Fi Direct (Simple AP) are not printed on this report.
4. On the computer's network connection screen or the smart device's Wi-Fi screen, select the same SSID shown
on the network status sheet to connect.
5. Enter the password printed on the network status sheet into the computer or smart device.
You can confirm the status of Wi-Fi Direct on the network status sheet.
Network Settings
button, press the
light turns on.
button within seven seconds, a network connection report is printed. Note that the SSID and
button until the light and the
24
light flash