Epson ET2710 Series User Manual page 17

User's Guide
Light Status
A paper jam has occurred.
❏ The printer was not turned off correctly.*
❏ Because the printer was turned off while
operating, the nozzles may have dried
and clogged.
* The power was turned off with a power
strip or breaker, the plug was pulled out of
the outlet, or an electrical failure occurred.
When the
simultaneously
An ink pad is nearing or at the end of its
service life.
When the
alternately
A borderless printing ink pad is nearing or at
the end of its service life.
The printer has started in recovery mode
because the firmware update failed.
Printer Basics
B b
light and the light flash
B
b
light and the light flash
17
Solutions
Remove the paper and press the
button.
If the paper jam error continues after removing the
paper and turning the power off and on again, paper
may remain inside the printer. Load A4 size paper in
the rear paper feed, and then press the
button to remove the paper inside. Load paper
in the portrait direction.
If the error cannot be cleared, contact Epson support.
❏ After clearing the error by pressing the
button, we recommend performing a nozzle
check. Cancel any pending print jobs.
❏ To turn off the printer, make sure you press the
button.
The ink pads need to be replaced.
Contact Epson or an authorised Epson service
provider to replace the ink pad
serviceable part.
When a message saying that you can continue
printing is displayed on the computer, press the
or button to continue printing. The lights
stop flashing for the time being, however, they will
continue to flash at regular intervals until the ink pad
is replaced.
The borderless printing ink pad need to be replaced.
Contact Epson or an authorised Epson service
provider to replace the ink pad
serviceable part.
When a message saying that you can continue
printing is displayed on the computer, press the
or button to continue printing. The lights
stop flashing for the time being, however, they will
continue to flash at regular intervals until the ink pad
is replaced.
Borderless printing is not available, but printing with
a border is available.
Follow the steps below to try to update the firmware
again.
1. Connect the computer and the printer with a USB
cable. (During recovery mode, you cannot update the
firmware over a network connection.)
2. Visit your local Epson website for further
instructions.
or
or
or
P
*1
. It is not a user-
*1
. It is not a user-