Printing A Network Status Sheet; Replacing Or Adding New Wireless Routers - Epson ET2710 Series User Manual

User's Guide
Related Information
"Printing a Network Status Sheet" on page 31
&
"Connecting to a Computer" on page 20
&
Message on the Network Environment
Message
*Multiple network names (SSID) that
match your entered network name (SSID)
have been detected. Confirm network
name (SSID).
The Wi-Fi environment needs to be
improved. Turn the wireless router off and
then turn it on. If the connection does not
improve, see the documentation for the
wireless router.
*No more devices can be connected.
Disconnect one of the connected devices if
you want to add another one.
The same SSID as Wi-Fi Direct exists in the
environment. Change the Wi-Fi Direct SSID
if you cannot connect a smart device to the
printer.

Printing a Network Status Sheet

You can check the detailed network information by printing it such as the maximum number of devices you can
connect by Wi-Fi Direct (simple AP).
1. Load papers.
2. Hold down the button on the printer's control panel for at least seven seconds.
The network status sheet is printed.
Note:
If you release the

Replacing or Adding New Wireless Routers

If the SSID changes due to the replacement of a wireless router, or a wireless router is added and a new network
environment is established, re-set the Wi-Fi settings.
Network Settings
Solution
The same SSID may be set on several access points. Check the settings on the
access points, and change the SSID.
After moving the printer closer to the access point and removing any
obstacles between them, turn off the access point. Wait for about 10 seconds,
and then turn it on. If it still does not connect, see the documentation
supplied with the access point.
Computer and smart devices that can be connected simultaneously are
connected in full in the Wi-Fi Direct (Simple AP) connection. To add another
computer or smart device, disconnect one of the connected devices first.
You can confirm the number of wireless devices which can be connected
simultaneously and the number of connected devices by checking the
network status sheet.
On the printer's control panel, go to Wi-Fi Direct Setup screen and select the
menu to change the setting. You can change the network name following
after DIRECT-XX-. Enter within 32 characters.
button within seven seconds, a network connection report is printed.
31